Git

If you attempt to push a large set of changes to a Git repository with HTTP or HTTPS, you may get an error message such as error: RPC failed; result=22, HTTP code = 411. This is caused by a Git configuration default which limits certain HTTP operations to 1 megabyte. To change this limit run within your local repository

git config http.postBuffer *bytes*where bytes is the maximum number of bytes permitted. For exmaple:

git config http.postBuffer 524288000

If customer use self compiled sniffer from git, (napatech card card not supported in static binaries provided by voipmonitor.org) set in sniffer's /etc/voipmnitor.conf

upgrade_by_git = yes
git_folder = /usr/src/voipmonitor-git

The sniffer will perform (after click on UPGRADE in GUI) make, service voipmonitor stop, make install, service voipmonitor start